Quick Reference Guide (Hardware)

Quick Reference Guide (Hardware)

The Proteus Hub connects seamlessly into your existing electronics, using NMEA2000 for data and power and providing an output display over HDMI. Usually, your Proteus Hub will be hidden out of sight with the primary display on your MFD, but if you encounter an issue it can be useful to check the Proteus Hub indicator lights and cables.



 

 

Indicator Light

·      Single Green Blink - Normal Operation

·      Double Green Blink - Powered, but turned off
(Proteus Hub can be turned on or off using the NMEA virtual switch panel)

·      Red Light – Error

·      Any Blue Light - Bluetooth connected

Connector Cables

·      NMEA 2000

·      Ethernet

·      USB for Touchscreen

·      HDMI

Antennas

·      Extra Terminal

·      BLE (Bluetooth)

·      WIFI

·      4G Cellular

Integral Heatsink

·      Helps keep the device operating at a cooler temperature.

 

·      Note: Proteus is powered by the NMEA 2000

    • Related Articles

    • Quick Reference Guide (Home screen)

      The two primary modes of the Proteus display are Map (2D) view, and 3D (simulation) view. To switch between these two homes screens, press the “Map” or “3D” button in the top right corner. The following pages describe the features available from the ...

    • User Guide Full Version 1.0

      Disclaimer Warning: Refer to important safety information in the user app guides, product documentation and review all warnings, limitations, and disclaimers before using this product This product is not a substitute for proper training and prudent ...

    • Home Screen

      Radar Display (Auto Gain/NM Range) Adjust Gain up (+) or down (-) to meet desired needs on the water. On compatible RADAR hardware, select Auto to have Proteus Auto-Focus manage your RADAR gain. Manually adjust Nautical Mile range up (+) or down (-) ...

    • Diagnostic Screen / Start up Screen

      When you start up your new Proteus hardware for the first time it will bring you to the Diagnostic Page. Note: Any configuration done through Initial Setup can be changed later. The Diagnostic Page is the first screen you will see as Proteus comes ...

    • Version Check

      NEWEST SOFTWARE: 1.5.0 (190) NEWEST FIRMWARE: 1.90 Follow the instructions below to check your version numbers and update your system if needed. About ProteusHub Versions The ProteusHub contains two distinct sets of software that must be up-to-date ...